OSH Park
Shared projects
- You need to sign in or sign up before continuing.
pogotest
by
unusual-thoughts.
2
layer board of
1.99x1.51
inches
(50.42x38.43
mm).
Shared on
August 14th, 2016 20:49.
R2D2 Relay board
by
DarrenP.
2
layer board of
1.94x2.00
inches
(49.20x50.80
mm).
Shared on
August 14th, 2016 18:07.
Relay board to control power to R2’s legs and dome motors
RPi PWM Level Shifter Hat
by
jer.
2
layer board of
2.56x2.23
inches
(65.10x56.62
mm).
Shared on
August 14th, 2016 15:29.
Raspberry Pi Level Shifter Hat for driving WS2812/SK6812 LEDs.
Parts Required: - 1 TX0104 (TSSOP14) - 2 10uF (SMD 1206) Capacitors - 2 0.1uF (SMD 0603) Capacitors - 1 Schottkey Diode (SMD 1206) - 1 2A Fuse (SMD 1206) - 1 100mil Raspberry Pi GPIO Female Header
For more information, please see: https://github.com/jgarff/rpi_ws281x
Please note, when not powering the PI from the HAT, remove F1. If powering the Pi from the hat, be sure to only use a 5V regulated power supply with enough current capacity. This hat does NOT protect against over-voltage on externally connected supplies!
Use at your own risk. I take no responsibility for any damage or injury. This board has been tested and is known to work on Raspberry Pi B+ and later revisions.
Firethings 1.3
by
aliafshar.
2
layer board of
1.05x1.00
inches
(26.77x25.50
mm).
Shared on
August 14th, 2016 04:40.
Firethings 1.3
Low Battery LED Through Hole For Lipo
by
Helder.
2
layer board of
1.10x0.69
inches
(27.84x17.48
mm).
Shared on
August 13th, 2016 22:41.
Turns LED on when battery is at or below 3.26v