PLEN Playground - Forum

Hi, Tueddy.

Thank you for your cheering! We work for people get more fun through PLEN, always have, always will :)

1.) OK, I'll think about this.

2.) No, "<VI" command has implemented since firmware version 1.1.0. For example, I have installed firmware version 1.2.1 to my PLEN2, and then send the command, I can get json like below.

```json
{
    "device": "PLEN2",
    "codename": "Cytisus",
    "version": "1.2.1"
}
```
I thought that you are not using PLEN2's baud-rate. PLEN2 and other component to communicate with baud-rate of 2,000,000.
(It's defined here: https://github.com/plenproject/plen__fi … .h#L37-L41)

3.) Oh... I had not noticed the typo X(  This bug has fixed currently, please check below.
https://github.com/plenproject/plen__fi … 386213f120

4.) That's right you intended.

Hi,

> ... but in Arduino IDE i cannot set to 2,000,000?
Yes, we use other terminal emulator to communicate with PLEN2. (In japan, the most popular one is Tera Term.)
If you want to use other baud-rate, please change their definition that described before, or write "Serial.begin(xxx);" directly in the setup().
(By the way, the firmware calls Serial.begin() at here.)

If you are interested, let get the additional information why we are using baud-rate 2,000,000.
(Reference: http://wormfood.net/avrbaudcalc.php?pos … detables=1)