PLEN Playground - Forum

<p>Aluminum alloy and aluminum parts in the pre-processing process, the need to pay attention to the problem: Although the surface of the fine processing of the original oxide film was born at the beginning, easier to remove, but oily heavy, especially in and around the hole (due to machining The process of lubrication needs to be added), this type of workpiece must be  external wall finishes for buildings  cleaned with organic solvents, if not directly with alkaline cleaning is difficult to remove the oily heavy net, and fine processing can not withstand the strong alkali corrosion for a long time, the result will affect the workpiece The roughness of the surface and tolerances, eventually there may be waste. </p> <p>aluminum alloy and aluminum casting molding parts in the pre-treatment process need to pay attention to the problem. Casting parts are not all machined surface machining, leaving the surface without casting process is too thick oxide layer formed during casting, and  Best Composite Deck Material Images  some also sand, this time should be first machined or sandblasting method to remove This part of the original oxide film, or after caustic and then processing, the only way to not only net raw parts of the raw oxide layer, but also to avoid the size of the machined parts to change the size. </p> <p>aluminum alloy and aluminum after heat treatment or welding process parts in the pre-treatment process need to pay attention to the problem: put cesium Arts requirements, the workpiece into the heat treatment or welding process before the need for organic solvent cleaning, in addition to net surface oil, but At present, generally can not do this, so the surface of the workpiece to form a layer of oil-burning coke, this layer of coking in the organic solvent is  46 in. interior decking slab  difficult to remove the net, if soaked in lye will cause local corrosion, pitting or cause Uneven, seriously affecting product quality.</p>