I can't use "PLEN connect" for PLEN2 dev

wingcloud · 2016-05-29 02:51:35

Hello again,

I enjoy to control my USB-connected PLEN2 dev by online Motion Editor and Control Server 1.3.0 now.
Next, I'd like to control it wirelessly. So I tried to use "PLEN connect" (iOS), but I failed...

I connect my iPhone to my PLEN2 dev through wifi(SSID:"PLEN2devXXX..", PASS:"plenproject")
then my PLEN2's LED blinks when I tap control icons of PLEN connect.
I think my PLEN2 receives some signals from PLEN connect successfully,
but it never moves.
From my understanding, PLEN connect runs installed motions in my PLEN2.
I already installed all motion samples to my PLEN2 dev by MotionInstaller.
What's wrong?

Thank you for your kindness.

Last edited by wingcloud (2016-05-29 09:02:48)

Guvalif · 2016-05-29 10:16:00

Hi, wingcloud

I think the issue was caused by the wrong baud rate has been written in your control-board.
If you had written below firmware to your control-board, please edit baud rate 2,000,000 to 115,200.
-> https://github.com/plenprojectcompany/P … stem.h#L42

wingcloud · 2016-05-29 12:05:19

Hi, Guavalif

It worked!
I need to change BLESERIAL_BAUDRATE if I use wifi connection instead of BLE, right?
Thank you so much.

By the way, today in Sunday. Don't work too hard! :)

PLEN Playground - Forum

#1 2016-05-29 02:51:35

I can't use "PLEN connect" for PLEN2 dev

#2 2016-05-29 10:16:00

Re: I can't use "PLEN connect" for PLEN2 dev

#3 2016-05-29 12:05:19

Re: I can't use "PLEN connect" for PLEN2 dev

Board footer