PLEN Playground - Forum

<p>doors and windows and other openings around the grid cloth, all four corners should be attached to a layer of grid cloth to strengthen the entire grid should be around the hole in the package and additional mesh cloth above. 3. Apply polymer mortar on the front and sides of the extruded board at the entrance to the hole and the mesh cloth. (Extruded polymer mortar is only allowed at the edge of the extruded board here). </p>
<p>Will be thrown before the grid cloth flip along the thickness, and pressed into the polymer mortar. 4, the entire grid cloth along the horizontal direction Beng straight, pay attention to the mesh cloth curved side inwards, with a trowel from the middle up, the next two sides of the grid cloth smooth, so close. Mesh horizontal overlap width of not less than 100, lap perpendicular to the length of not less than 80, lap joints with </p>
<p>mortar to supplement the bottom of the vacancy mortar, mesh cloth shall not be pleated, hollowing, Alice edge. 5, at the concave and convex line angle, a narrow grid should be buried in the bottom of the polymer mortar, the entire grid in a narrow grid cloth, lap width 80. 6, in the wall at both sides of the yin and yang corner of the two-way grid around the angle overlap lap, overlapping lap width of not less than 200. 7, </p>
<p>joist spacing for plastic decking<br />
timber wood plastic composite floor<br />
plastic ranch fence panels</p>