You are not logged in.
I tried several times, I reseted the router, computers, raspi, etc... a lot of times. I give up: I can't get my nanoDLP working again after installing the last build. A friend told me the same shit happened to him installing this build.
www.nanodlp.com/dashboard says "no printer detected", instead, my router let me see the rasp connected... anyway, there is something evil in the last build afecting conections with nanoDLP. I had to reinstall the firs build I had (too old, 1473) because I can't get another build newer than that, except the bad last one.
Please, take an eye on this because I think it's a serious thing.
Regards
Last edited by LoRaX (2018-04-13 13:00:58)
Offline
Try use upnp (network area) to ssh into device and checkout what is going on. NanoDLP has not changed much since 1473 on network front.
Offline
I had installed 1473 build, everything was OK again.
I read your message so updated again nanoDLP to the last build ------> Could not connect to printer again.
Install putty, tried to connect via SSH ----> conection refused. (I checked nanoDLP IP (192.168.1.133) through "Advanced IP Scanner" and router interface and nothing...
Last edited by LoRaX (2018-04-13 16:20:58)
Offline
Ok, I got it. Reinstall all, updated and now working "fine". I don't know why this happens...
Now the problem is that I can't upload any file if it size it's (for example) 30MB or 50MB: break connection with nanoDLP and when I reconnect it says "plate is corrupted". Previous builds had not this problem, what's wrong ?
Offline
Please, share a debug file.
Offline