Z-axis Endstop Homing Errors?

MrAntza · 2019-02-07 15:32:24

Hi, Im trying to solve how to I should install endstops and which direction to motor, I watched a lot videos and all data what I founded, and tested differend complications an few hours! but didnt find right setup..

I have moving motor, but its not moving than just one direction if try Z-axis movement +1mm or -1mm buttons etc
Example it moves physically to up when I clicking up-button, but when click down; it wont move.

When I try homing options, nothing happening, no movement.

"Arrrgh..! Help"

Shahin · 2019-02-08 06:26:35

Have you tried changing limit default state?

MrAntza · 2019-02-08 09:00:59

What you mean by that? Or where to change it?

Also command G28 (homing) does nothing

Edit:
It does not go up even try any movement commands, only down until hits frame.
It doesnt take any change when activates endswitch..
No matter if I put endswitch to B-place from T-place, printer does not take it

Edit2:
I founded another article about optical endstop when I started think if thats problem its NC either NO type..
I ripted it of and now platform is moving up and down when I want, so I have to use another like swithces for now If there is no any way to reverse it in programm? Is there?

Last edited by MrAntza (2019-02-08 09:45:02)

Shahin · 2019-02-08 13:44:08

On machine settings page change limit default state to fix the issue.

MrAntza · 2019-02-08 15:38:29

Im trying find it but cant see there setup like that, is it under some other "menu" what must be opened?

nanoDLP

#1 2019-02-07 15:32:24

Z-axis Endstop Homing Errors?

#2 2019-02-08 06:26:35

Re: Z-axis Endstop Homing Errors?

#3 2019-02-08 09:00:59

Re: Z-axis Endstop Homing Errors?

#4 2019-02-08 13:44:08

Re: Z-axis Endstop Homing Errors?

#5 2019-02-08 15:38:29

Re: Z-axis Endstop Homing Errors?

Board footer