nanoDLP

Hi there,

can someone please give me hint for the pinassignment in the GPIO Movement part of nanodlp ?

Nanodlp shield shows Motor Error ... the green LED ... when I enable motor.

The Shield is Nanodlp-Shield V1.1 from aliexpress .. sorry i am not allowed to post a link.

I have set the pins as described:

StepGPIO for Z-Axis : BCM25
Direction GPIO : BCM 23
DirectiDriver Enable GPIO : BCM 22
Endstops disabled
Enable GPIO State Gigh
Enalble GPIO Mode: on Boot

Thanks in advance

Last edited by Hepman (2018-10-22 11:05:50)