nanoDLP

As my username no doubt indicates, I am very new the 3d printer fraternity and so I am having to digest huge amounts of data of the subject. Was has cut a lot of that time, is not even considering FDM, which was what put me off 3d printing in the first place. Such poor quantity did really seem worth the effort. However, to the question at hand, as an example if I had a 1080p project (the Acer) and from that attempted a build area of 200 mm x 100 mm @ 100 microns say, can a second projector at the same specifications, be introduced to increase this build area to 400mm x 200mm, at the same resolution? I have seen two other post, where the user has attempted to get a steer on this, however the threads have always been steered away from the original topic, with no really answer achieved.

Assuming the projectors can be aligned, with a small amount of overlap, and raspberry pi driving each projector in a master/slave relationship, can this be achieved with nanodlp?

Any direction on this would be greatly appreciated.

Regards,

BabySteps12!