You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2018-08-08 19:47:29
- JohanStrom
- Member
- Registered: 2018-08-08
- Posts: 5
Extremely slow moves after updating NanoDLP
Hello! I've successfully used NanoDLP for a while now with my Wanhao Duplicator 7, but since upgrading to 1852 (not sure from what, but at least something a month and a half older) my printer still "works" but the lift/layer change cycle is INCREDIBLY slow compared to before. I can't figure out what's changed because all my Gcode and settings are exactly the same as before. Did something change in the software without telling me?
Offline
#2 2018-08-09 04:20:29
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 2,737
Re: Extremely slow moves after updating NanoDLP
Movement speed being controlled by F parameters on gcode box or on firmware on RAMPS side.
Offline
#3 2018-08-09 12:56:18
- JohanStrom
- Member
- Registered: 2018-08-08
- Posts: 5
Re: Extremely slow moves after updating NanoDLP
I'm not sure, how can I check? It's a NanoDLP install from 3dprinterwiki and the printer is running the repetier firmware modified for D7 recommended on the same site.
I just upped all the speed numbers by an arbitrary amount until it moves as fast as it used to now, but that feels a little unscientific to me 
.
Offline
Pages: 1