NanoDLP Calibration Test

Larac · 2018-09-13 20:11:26

Tried the Calabration test.
2,3,4,5,6,7,8,9,10,11,12

5 and 5
30mm cube

Clicked generat.
10 min later no change.

Looked at layers it only made 1.

Tried again with 20mm cube.
Same thing.

Any ideas?

Or what settings should I be using?
Phrozen Shuffle if that matters.

Larac · 2018-09-14 01:56:03

The preview layers says plate not complete.
Shows only 1 layer.

Is there another way to do all the cure times on one plate?

Shahin · 2018-09-15 05:31:43

Refresh the page after 1 or 2 secs. Status for autocalibration does not change, and generation is very quick

nanoDLP