You are not logged in.
- Topics: Active | Unanswered
#26 2019-05-01 18:51:16
- macdarren
- Member
- Registered: 2017-03-20
- Posts: 289
Re: Horizontal Size Compensation in the resin profiles...
An I correct that this feature (burnin-erode) is supported in the Rpi version but if using a remote slicer it will be ignored?
Could not get it to work at first, but then suddenly it started I then realized my remote slicer went offline....(remote is linux ver 2177)
Offline
#27 2019-05-02 05:04:32
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 2,737
Re: Horizontal Size Compensation in the resin profiles...
Make sure both versions are same.
Offline
#28 2019-05-02 14:10:26
- macdarren
- Member
- Registered: 2017-03-20
- Posts: 289
Re: Horizontal Size Compensation in the resin profiles...
I can't seem to get a newer Linux system (desktop remote slicer) than 2177 using: wget -P ~/Desktop/ "https://www.nanodlp.com/download/nanodlp.linux64.zip"
Is there a different way to get the Beta?
It does show in blue on the dashboard that there is a newer version available but since there is no internal updater
in linux using wget is all I know how to do.
Last edited by macdarren (2019-05-02 14:31:24)
Offline
#29 2019-06-06 18:46:58
- DrNK
- Member
- Registered: 2016-11-19
- Posts: 90
Re: Horizontal Size Compensation in the resin profiles...
Positive value makes object smaller and negative - bigger?
Offline
#30 2019-06-07 15:01:02
- macdarren
- Member
- Registered: 2017-03-20
- Posts: 289
Re: Horizontal Size Compensation in the resin profiles...
correct...I use -0.3 to reduce elephant foot issue on burn in layers of models printed directly on the platform
Offline
#31 2019-06-07 20:23:12
- DrNK
- Member
- Registered: 2016-11-19
- Posts: 90
Re: Horizontal Size Compensation in the resin profiles...
correct...I use -0.3 to reduce elephant foot issue on burn in layers of models printed directly on the platform
If you use -0.3 (negative) for reducing - I`m wrong 
Positive value makes object smaller and negative - bigger?
Offline