You are not logged in.
Pages: 1
I saw this on nanodlp download page RAMPS Board
RAMPS board are Arduino based 3D printers control board.
I check the firmware its for arduino uno and i want to use ardunio mega
So is fine to ger grbl for arduino mega or i musy use ardunio uno ?
NOTE i dont want to end codes etc
I made a try with arduino mega grbl firmware and the raspberry pi communicates woth the mega but the Z axis doesnt move
Offline
On the contrary,
Ramps boards are made to work with MEGA..
You can however configure GRBL to work with both an arduino with with a stepper shield. Or you can use a ramps running GRBL configured to run on a ramps board. See the Config header file and change the Mobo selection type.
If you want the end support for GRBL you will need ver 9j. otherwise. Look to loading up a ramps with Marlin for end commands.
Regards,
Mo
Offline
Pages: 1