You are not logged in.
Based on Marlin 1.0.0 forked from mUVeDLP-Running. This version has EEPROM enabled and all the functionality of the added 'Z-move_comp' message after G1/G0 Z axis moves. This firmware will allow you to use the [[WaitForDoneMessage]] instead of populating your gcode with M400 commands. Source available on GITHUB, anyone that would like to contribute code is more than welcome.
Things I would love to address, when using a generic RAMPS board the ability to support the 2004 LCD Controller. Also trimming the menu items in Marlin to only include the necessary things to start a print. Printing from SD card.
Source is located here:
https://github.com/WheresWaldo/Marlin_KLD-LCD
Offline
New experimental branch created with all the projector serial 2 code stripped out of the source.
Offline
Experimental branch merged with master
Offline
Since the Marlin developers think that versions prior to 1.0.2 are more experimental than stable. I created a new branch and have been testing Marlin 1.0.2 modified with the 'z_move_comp' messaging. If you want to pull it from the GITHUB make sure you select the 1.0.2 branch.
Offline