You are not logged in.
Hi,
Until lately my NanoDLP worked fine then it started making my PI unresponsive as soon as I connect the printer. I updated to a new version and the problem seemed fixed but now it has appeared again. The pi boots fine on its own but as soon as i connect the printer usb cable to it, it stops responding. I tried reinstalling nanoDLP but the same happened.
I have it installed on top of raspbian on a pi 3 b+, my printer is a Wanhao D7
Any ideas what is going on?
Last edited by hartz_0 (2018-06-15 21:10:48)
Offline
Can you ping the rpi after connecting your printer?
Offline
nope, as soon as i connect the usb plug the request times out. I also tried a different usb cable, the same
Offline
So nothing to do with nanodlp, maybe it is electrical problem or something, try another board to see if it makes any difference.
Offline
I did a clean reinstall on raspbian and nano dlp and the problem seems fixed for now.. i will make a clone of the sd card so I can reinstall quicker next time..
Last edited by hartz_0 (2018-06-16 08:16:54)
Offline