nanoDLP

hey there
so suddenly my printer started to fail after 100+ layers into the print process

im using a muve3d setup(changed a lil bit their firmware a while back)

what happen is:
im sending a print
at the first couple of hundres layers all goes well

but the suddenly the printer is getting into a loop of the peeling procedure without projecting pictures
but the layers numbers do increased after every peeling cycle

its like it totally ignores the [[WaitForDoneMessage]]
the result is a big fail

G1 X{[[LayerThickness]]*90} Y{[[LayerThickness]]*10} F15
[[WaitForDoneMessage]]
G1 X{[[LayerThickness]]*10} Y{[[LayerThickness]]*90} F15
[[WaitForDoneMessage]]
G1 X1 Y1 F15
[[WaitForDoneMessage]]
G1 X-1 Y-1 F15
[[WaitForDoneMessage]]
G1 X{[[LayerThickness]]*(-99)} Y{[[LayerThickness]]*(-99)} F15
[[WaitForDoneMessage]]

at first all work fine and after random number of layers, the mess is starting to happen

tried to post links for downloading profiles but im not allowed...