nanoDLP

Wanhao D7. After upgrading to build 1919 my prints z-height was incorrect. I checked machine settings vs the D7.json on /Repo and microstepping was changed from 8 to 16, so i guessed this was the issue. Instead of checking everything, i decided to just import the machine profile.

I downloaded the D7.json and added details on Wifi (added ssid/pass). Should probably not have done that. After the imported machine settings, the wifi would not connect. Removed the SD card and did a clean install. Imported D7 machine settings.

After the reinstall - i cannot print. When i press start, i get the error msg:
External Call Problem exit status 127 sh: 1:pushover.sh not found

Also - My manual Z-axis controls only seem to work up and not down.

Before the reinstall, everything worked like a charm. What did i forget?

Best Regards,
Dr. Z

Last edited by Dr. Zoidberg (2018-12-08 01:43:14)