You are not logged in.
Pages: 1
It would be great to be able to fully use masks and determine cure times with them in the workflow. Unfortunately it seems that the default Mask isn't considered when generating a calibration plate. Or is it upon printing (doubtful)? Unfortunately the Preview for the Calibration doesn't show the mask as being applied. Without it, it makes it a little difficult to tune in anything that involves the use of masks unless I run manual (and time consuming) tests...much like before the wonderful calibration plate tool existed. Hopefully this can be applied at some point since I'd love to start using masks but need a way to tune the resulting exposure times.
Offline
Which build you are currently using?
Mask and auto-calibration have the same dilemma as chicken and egg.
First you need to know correct cure time to see where the prints are weak / strong so you generate mask. Maybe we need to have mask optional for calibration page and it applies based on demand.
Offline
Pages: 1