You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2018-04-26 14:09:41
- Varshil
- Member
- From: india
- Registered: 2018-04-26
- Posts: 3
Control motor with A4988
Can anyone give me a hd image or schismatic or rough drawing of below image.
i want to control motor with A4988 driver.
I have
Raspberry pi 3
A4988
5v 3.4A dc adapter
nema 17 motor
give some guidance.
Last edited by Varshil (2018-04-26 14:14:23)
Offline
#2 2018-04-26 14:53:10
- ToS
- Member
- Registered: 2017-09-18
- Posts: 24
Re: Control motor with A4988
I couldn't explain it better then the guy in the video did
https://www.thingiverse.com/thing:2749678
Last edited by ToS (2018-04-26 14:54:31)
Offline
#3 2018-04-27 19:52:09
- Varshil
- Member
- From: india
- Registered: 2018-04-26
- Posts: 3
Re: Control motor with A4988
Thank You,
I tried this on bread board it works. but during raspberry boot motor get some steps, motor rotate but skipping steps and making noise. simply motor rotate but not properly. i sat steeper current by set screw of A4988.
i am making printer with just HDMI lcd, no UV so i skipped that. and i want simple circuit so i skipped i2c, led and stop ray also. is this affects?
and also advice resin for just LCD printer?
I changed by paint 
Thank You.
Offline
#4 2018-08-29 15:14:38
- i9n0r
- Member
- Registered: 2018-07-25
- Posts: 8
Re: Control motor with A4988
This will make it easier.
Just 6 Wire ( 3 Signal waire E,S,D and 3 power wire 5V,12V,GND)
Offline
Pages: 1