nanoDLP

The connection problem appears to be my SD card being full. Not too sure as I've now got bigger problems. My problem with layers was to be fixed with new firmware which changed the line

#define DEFAULT_AXIS_STEPS_PER_UNIT   {36.36,36.36,400,400}

to

#define DEFAULT_AXIS_STEPS_PER_UNIT   {36.36,36.36,1600,1600}

Changed nothing else except minor adjustments on the motor drivers and now I get smoke, lots of smoke. Is that possible from just adjusting the motor drivers? I put a new driver in that wasn't touched and still smoke.

Not sure what's frying, but I can't even get the USB to work.

It worked perfect for 3 hours, now the same problem.

Ran it through SSH, still no change. mUVe suggests I reinstall the sd card, so will give that a shot and let you know. Thanks again.

No blinking red light. What is the easiest (noob) way to shut down the wifi?

Just had it working on 192.168.0.11, now once again not working.

The raspberry pi shows up on my routers connected devices, yet can't access the IP address.

I guess until I get the nanoDLP running, this problem will have to wait. Thanks for the help so far.

I have no access and did trying pinging the IP. No response.

Was set to 100 microns. It's like it prints 5 layers, misses 5 layers. Is there anyway of me adding a photo to this post?