You are not logged in.
Pages: 1
The LCD works when using the D7 software. When using NanoDLP the light come on and the LCD just turns on (BLACK) then goes off.. I can't get any of the calibrations to work.
Offline
You need patched firmware as there is command to turn lcd on and etc. Follow guide below.
https://3dprinterwiki.info/d7/d7-nanodlp-settings-2/
Offline
I have tried that with no luck. But I will try again.
Offline
@g713 Make sure you use the D7 specifically modified firmware, not just any modified firmware. See the D7 Facebook group or the wiki pages for this.
https://3dprinterwiki.info/wiki/wanhao- … ll-option/
Last edited by WheresWaldo (2017-09-05 14:16:40)
Offline
Pages: 1