nanoDLP

pi@raspberrypi:~ $ ls -l /home/pi/printer/db/
total 20
-rw-r--r-- 1 root root 1637 Apr 29 13:57 buttons.json
-rw-r--r-- 1 root root  284 Apr 29 13:14 calibration.json
-rw-r--r-- 1 root root 1739 May  3 13:44 machine.json
-rw-r--r-- 1 root root 1435 May  3 13:50 plates.json
-rw-r--r-- 1 root root 3519 May  3 14:02 profiles.json
pi@raspberrypi:~ $ ls -l /home/pi/printer/distro/muve3d/opt/db/
total 16
-rw-r--r-- 1 pi pi 1984 Apr 25 15:21 buttons.json
-rw-r--r-- 1 pi pi  307 Apr 25 15:21 calibration.json
-rw-r--r-- 1 pi pi 1901 Apr 25 15:21 machine.json
-rw-r--r-- 1 pi pi 2779 Apr 25 15:21 profiles.json

> Keep dashboard open on a tab, change distribution, checkout dashboard error reports, do you see anything important?
you mean, check the Application log on the nanoDLP dashboard, while changing distribution?

there was no event reported on the dashboard application log
something I didn't mentioned earlier, I also tried to use the update instructions on the muve documentation, through ssh, but ended up in the same 1149 version.
How do I know in which distribution am I? I can only tell by the uploaded printer profiles and some Gcode in the hardware setup

Hi,
my build file does say "muve3dls", so I suppose the change worked
but as I said earlier, usually this change would upload some specific "printer profiles" and the inclusion of some custom Gcode to work with the mUVe printer.
thanks