nanoDLP

I bought a HS-5065MG servo motor to see if I could reduce audible noise and stutter when using the shutter on my projector. I cannot seem to get it to work. It moves once then stops working.
My previous Servo works fine: TowerPro's SG1050 although super loud and stutters..

The specs seem similar so I am unsure how to get it to work. I am powering it off a USB cable plugged into a powerbar. The Signal is running through Raspberry pi3

Running this on the mUVe3D Ultipro+

Using Gcodes from mUVe3D's settings:

Shutter open:
M280 P2 S160
Shutter closed:
M280 P2 S10

Servo Pulse Width Open
1400

Servo Pulse Width Close
700

Servo Signal Length
1000

Last edited by jneilon (2017-03-23 18:49:00)