You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2017-10-13 19:10:11
- Yianni-VJ
- Member
- Registered: 2016-05-24
- Posts: 59
Over or Under Exposed?
Can I get some advice about fine tuning my prints?
My printer is a bottom up, focused at 40um in XY and 25um in Z axis.
Antialias enabled.
The hole in the picture below is .5mm diameter.
The resin used is B9 Emerald, which has additives to facilitate castability, but makes it a little harder to print fine details compared to crisper resins.
To get a rounder hole, should I increase or decrease exposure times?
Last edited by Yianni-VJ (2017-10-14 10:16:28)
Offline
#2 2017-10-14 07:10:51
- MaxJewels
- Member
- Registered: 2017-08-10
- Posts: 38
Re: Over or Under Exposed?
Can I get some advice about fine tuning my prints?
My printer is a bottom up, focused at 40um in XY and 25um in Z axis.
Antialias enabled.
The hole in the picture below is .5mm diameter.
The resin used is B9 Emerald, which has additives to facilitate castability, but makes it a little harder to print fine details compared to crisper resins.To get a rounder hole, should I increase or decrease exposure times?
The picture is not visible
Last edited by MaxJewels (2017-10-14 07:12:34)
Offline
#3 2017-10-14 10:17:34
- Yianni-VJ
- Member
- Registered: 2016-05-24
- Posts: 59
Re: Over or Under Exposed?
Oops, sorry...
I update the post, thanks for the heads up!
Offline
#4 2017-10-14 10:38:26
- MaxJewels
- Member
- Registered: 2017-08-10
- Posts: 38
Re: Over or Under Exposed?
Oops, sorry...
I update the post, thanks for the heads up!
the photos do not understand much, but in theory should lower the cure time, it would seem overcuring
Offline
Pages: 1