You are not logged in.
Pages: 1
when editing a profile the infill parameters seem to be getting tested for valid values even when infill is turned off...
While this might be ok in theory it would be nice if at least the default values of zero would be accepted...or sensible defaults be the default.
Offline
Good point. What should the defaults be anyway???? I can't edit a profile unless i use something!
Offline
well if you leave the infill off then it seems most any reasonable number would work I use Hex, 5, 4, 5, 80
This issue may have been corrected in the recent betas...at least t hasn't come up for me In the last day or so....
Offline
Obviously much ado about nothing as I noticed that the parameters were not enabled after I posted <blush>.
Offline
Pages: 1