You are not logged in.
Pages: 1
Hi All,
I'm having a much more difficult time than I think i should be having getting NanoDLP on a RPi to cooperate. It seems that everything i've tried hasn't resulted in this working at all. I've uploaded the required firmware for the Duplicator 7 to work with NanoDLP but it is still not showing up when attempting to print. It says that it can't detect a D7 there, but when i test a print it just sticks at the first layer and never progresses...
Offline
did you change the firmware too?
Offline
did you change the firmware too?
Yes, I uploaded/flashed the proper firmware for the Duplicator 7 according to a couple posts I found.
Offline
If it stall on the first layer, it is clearly firmware or gcode issue.
Offline
If it stall on the first layer, it is clearly firmware or gcode issue.
gcode issue? How would i determine? I used the firmware flasher on Windows to push it to the D7. Seemed like it took it properly.
Offline
Maybe it is wrong firmware or duplicate [[WaitForDoneMessage]]. I believe you could find the issue by checking out threads on D7 facebook group.
Offline
Often if it appears to work but not actually print it has to do with the resin profile and specifically in the gcode Before layer and gcode after layer sections
Offline
I guess i'll have to wait until I have it infront of me again so I can give you guys more details...
Offline
Your best bet is probably to find somebody who has a D7 ( i don't) and more importantly using the same firmware as you and ask them to share a resin profile with you. This will contain the previously mentioned before and after layer Gcode. Then just edit that to suit the resin you plan to use.
Offline
Pages: 1