nanoDLP

eg,  several items should be placed in the upper right corner   ,,click  Add Support With 3D Editor ,  A window opens and you need to click   Plate view,   
and table construction upside down,and you need to put in the lower left corner so that the model comes to the right-hand corner,
Button  DO NOT ROTATE   no work. only  90 work.and Each time you need to set the parameters. Decrease Mask Intensity .center origin and Mask File

if you need to edit the position of the part you need to remove the plates and do everything first.....because if you open 3D>>>EDIT FILE>>> PLATE VIEW
Models automatically come to the center,and it is no longer possible to edit

here was this problem with the mask,but I found the problem      post#92   2017-11-02 16:47:20

https://www.nanodlp.com/forum/viewtopic.php?id=142&p=4

need to set the parameter  Decrease Mask Intensity......why this parameter in the window  Add Plate,,,it is necessary to transfer,,  Mask Generation Wizard
to get out the final working mask,,and if you press  Display Mask Preview  opens   final working mask,,with color for check

if I generate a new mask, it is not automatically saved in  setup  >>projector  mask..(I waited a long time)
and  if  save  mask in  a third-party folder..and  import  .but no  add....for adding  need remove  mask  ...close/ run nanodlp   and  add  mask

why need  parameter  Rotate Layers    in the window  Add Plate  if have  in Edit Profile  .
and if you change Horizontal Resolution Vertical Resolution,Display  automatically rotate
if the user needs to rotate the model  ,, if there isn  Plate view

1),,,adding Slicing start button in the Plates window

2)...if click  Add Support With 3D Editor, opens    Plate view,

3)..construction table in normal position,,if the model is set at the top right,and after cutting also at the top right

4)..adding mirror button  in  Plate view,

5)...grid make it permanent on construction table

6),,,adding  keep the position of models  on construction table,,if you open 3D>> EDIT FILE, so that the models are as originally set..
and could  add  model  or something to remove or move or twist  and save  and after that click  Slicing start button

HI Shahin

I know, I checked but tests showed
there is no difference if the win is enabled or not

PC ip192.168.0.103  Constant  in the router
PI   ip192.168.0.101 Constant  in the router
in setup  in pi  TCP 80    in  TCP ip port  of slicer   enter 192.168.0.103 or leave empty  (did restart  ri )

I think that the remote slicer  not active
maybe I'm not typing in correctly ? I only write  192.168.0.103,,how right?
or something else that needs to be configured in the router?
or something else that needs to be set up in the PC   WIN 7 64?