You are not logged in.
My Z axis stepper motor moves correctly under the calibration tab, but does not move at all when printing.
Could this be a resin profile problem?
Offline
If you are using RAMPS, yes it is gcode issue.
Offline
I cannot get the z axis stepper motor to change speed.
It only moves at a very slow rate.
Even if I use a direct g code in the terminal, like:
G1 Z-250 F700
It just creeps along barely moving and should go much faster
?
Offline
Pyper,
If you are using RAMPS, you need to check firmware settings on RAMPS side.
Offline