You are not logged in.
My Arduino reset just after the tilt command so it is stuck in that position. Anyway of returning from tilt? The command doesn't work I presume it needs to have the Resin Drain command first to allow it to return. Anyway of fixing this without manually putting the plate back in the correct position and recalibrating.
~ mUVe3D UltiPro+
Offline
Try sending M653 manually through terminal tab. see if it fixes the position.
Offline
Thanks I will try it next time. I couldn't figure it out in time so I just recalibrated. Someone else suggested turning off the arduino send the tilt command turn back on the arduino and send return from tilt.. a bit of a workaround but sounds like it might work to.
Offline