You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2017-09-07 17:03:55
- Rigra
- Member
- Registered: 2017-08-20
- Posts: 8
complete layer in a hollow model.
Hi, I'm runinng build 1589. I uploaded an STL hollowed and supported in meshmixer, and when I slice it in NanoDLP, noticed something stange from layer 369 to 397 the model apears solid, and then it becomes hollow again. I double check the STL, and the geometry is completly hollow, so I don't understand why this is happening. Am I missing some settings that create this wall?
Layer 366 Hollow:
Layer 397 Solid:
Layer 400 Hollow Again:
Offline
#2 2017-09-07 17:32:24
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 1,834
Re: complete layer in a hollow model.
Try netfabb, maybe there is shell. If netfabb does not found any issue, I need STL file to checkout logic.
Offline
#3 2017-09-07 18:47:36
- Rigra
- Member
- Registered: 2017-08-20
- Posts: 8
Re: complete layer in a hollow model.
ok, I have to install netfabb, I'll doit in the weekend and then report my results.
Thanxs
Offline
Pages: 1