You are not logged in.
Pages: 1
Hello Shahin,
I have upgraded NanoDLP to the version 1198.
Now NanoDLP crashes immediately, if it try to control the projector with serial interface.
Last edited by Xmike (2016-07-21 19:03:49)
Offline
Mike,
I could not reproduce the issue. Even with manual buttons you experience this issue?
Do you remember last build which you have not experienced this issue with?
Offline
Hello Shahin,
To reproduce the problem, I do this:
Projector is already turned on, then
"Setup" -> "upgrade to the beta version",
then as shown in my movie, turn on the projector again.
Afterwards I have to restart RPi.
If I try the latest stable version with "Setup" -> "Upgrade to the latest stable version", it changes nothing, unfortunately.
The latest stable version for me was "Build 1194"
Last edited by Xmike (2016-07-22 09:43:30)
Offline
Mike,
I could find the problem at last. Fixed on the beta version.
Offline
Pages: 1