You are not logged in.
- Topics: Active | Unanswered
#1 2017-12-05 14:57:49
- georgei
- Member
- Registered: 2017-09-30
- Posts: 20
NanoDlp doesn't accept hole numbers as exposure times when you correct
I have been try to correct my exposure times in a couple of resins.
So I have gone to change the value from 17 second to 15 seconds.
When I have go to save the resin came an error:
"The exposure time must be 14.99999 or 15.0000099"
This was not happening in the previous version.
Is this a bug?
Thank you,
George
Offline
#2 2017-12-06 04:00:54
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 1,834
Re: NanoDlp doesn't accept hole numbers as exposure times when you correct
Could you provide a screenshot?
Offline
#3 2017-12-06 07:40:56
- elshad66
- Member
- Registered: 2017-03-31
- Posts: 32
Re: NanoDlp doesn't accept hole numbers as exposure times when you correct
HI
I had this problem 2-3 times, but with Normal Layers Layer Thickness 50.000004
I corrected but the program did not accept
"The Layer Thickness must be 49.999999 or 50.000004"
but I did not pay attention,after some time itself corrected
Last edited by elshad66 (2017-12-06 14:59:36)
Offline
#4 2017-12-06 08:17:39
- georgei
- Member
- Registered: 2017-09-30
- Posts: 20
Re: NanoDlp doesn't accept hole numbers as exposure times when you correct
I have attached a screenshot.
George
Offline
#5 2017-12-06 20:34:59
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 1,834
Re: NanoDlp doesn't accept hole numbers as exposure times when you correct
Probably a new bug on a browser. What is it firefox or chrome? and which version?
Offline
#6 2017-12-06 20:36:57
- georgei
- Member
- Registered: 2017-09-30
- Posts: 20
Re: NanoDlp doesn't accept hole numbers as exposure times when you correct
It is Opera 49.0
George
Offline