You are not logged in.
Pages: 1
Created a SLC file, created a plate, it is underscaled.
Checked display resolution, microns, reopened SLC to double check dimensions, everything is ok.
Opened sliced raster, underscaled.
Bug ?
Offline
Update, also slicing from stl same problem. Checked "override x/y" into profile it's 100%
Offline
Are you sure your projector calibrated correctly?
Currently we have XY resolution on setup page another one on profile level which overrides setup level one and also percentage based modifier.
Offline
Are you sure your projector calibrated correctly?
Currently we have XY resolution on setup page another one on profile level which overrides setup level one and also percentage based modifier.
Double checked, I'm quite sure.
Dynamic calibration works fine and white also.
Update: Dynamic raster file is ok, 2560x1440 and pattern fill the whole area, sliced objects are zoomed out into layer rasters but raster size is ok 2560x1440
Last edited by Gatto (2017-02-19 10:36:39)
Offline
Found a workaround, override 30% raster is quite ok
Offline
Ahhhhhhhhhh
into profile, the override is not percentage but micron....
Offline
Pages: 1