You are not logged in.
Pages: 1
Hi, first post.
I have searched the forum and cannot find how to stop an stl from being anyalyzed.
It has been going for 2hrs+
I have switched off the Pi3, restarted both nanodlp and the Pi3 but each time it it goes back to 'analyzing stl file'.
I have even tried deleting the plate, but still it continues.
Is there a way to do this?
many thanks
Bixx
Offline
You can remove STL source file. I will try find solution to this problem.
Offline
Thanks for the suggestion. I somehow managed it after about 5hrs. A kill switch would be nice to stop it restarting automatically.
Last edited by Bixx (2017-05-15 20:43:25)
Offline
Pages: 1