You are not logged in.
Pages: 1
Hello everyone,
I think I have correctly configured the electronics (I use Grbl) when calibrating the Z axis, it moves correctly. It moves very well.
When I turn on the projector it also lights up correctly.
But it does not work when I try to print something.
Can somebody help me.? I can not find the answer in the forum.
Thank you very much.
Offline
You can fix your issue following this thread http://www.nanodlp.com/forum/viewtopic.php?id=116
Offline
I had the same issue. Problem was with the "Waitfordonemessage" commands in gcode. The grbl 0.8c that I am using does not seem to be compatible with the RAMPs sync module in nanodlp. Remove those commands and see if it works. You may want to put a delay instead.
Offline
Thanks for your answer. I use Grbl version 0.9.
Offline
Pages: 1