If something is wrong with the steering or throttle control of your MINI-Z RWD or FWD and it does not go away by resetting the chassis, please try resetting the Syncro KT-531P transmitter following these steps:
FAQ Category: All Categories
If something is wrong with the steering or throttle control of your MINI-Z Sports or MINI-Z Moto Racer and it does not go away by resetting the chassis, please try resetting the Perfex KT-19 transmitter following these steps: Turn off the transmitter if it is on. Make sure that the […]
How can I reset the Perfex KT-19 transmitter?
If your MINI-Z has the Chase Mode, it might have been activated. In order to deactivate it, long push the pairing button on the chassis until the LED blinks once. Refer to this link for more information about the Chase Mode.
My MINI-Z is much slower when going forward than going ...
Please check if the motor wires are securely connected to the main board. Remove batteries from the chassis. Tighten the screws that connect motor wires to the main board.
My MINI-Z does not go forward or backward though steering ...
Most likely the safety protection circuit (poly switch) attached to the motor has cut off the current because of high load. Please try the following: Remove the motor and check if the wheels and drive train are spinning freely. Note: do not touch the motor or poly switch while they […]
My MINI-Z suddenly slows down and stops though steering is ...
There might be contact failure. Please try pushing the batteries to the positive terminals of the battery holder.
My KT-19 transmitter does not turn on even though new ...
The sensorless brushless system used in the MINI-Z VE models can show stuttering or cogging at very low speeds. In order to avoid stuttering or cogging, the lowest possible speed of the MINI-Z VE models is faster than brushed motor models.
My MINI-Z VE cannot run very slowly even at the ...
The sensorless brushless motor system used in the MINI-Z VE can stutter or cog at the low speed range and you don’t need to worry about the behavior unless it is too bad.
My MINI-Z VE stutters at low speed
If you use the Perfex KT-18 transmitter, you can reverse or change back the throttle direction by press and hold the backward trim button, (1) in the diagram below, for about 3 seconds until you hear a short beep tone.