Shared projects

10*7135_V1.0

2 layer board of 0.69x0.69 inches (17.42x17.42 mm).
Shared on October 9th, 2014 07:26.

new 7135 based linear driver for EITHER the ATTiny10 or the PIC 10F322. see thread http://budgetlightforum.com/node/33927. Do not populate zener for single cell builds

U1 is PIC 10F322
D1 is SOT-323
Z1 is SOT-123 (only populate if needed)
C1 is 10uf 0805 X7R (for clicky builds using tterev3’s FW a resistor is stacked over the cap)
Any number of 7135’s may be populated, no need to have them at any specific pad’s

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project

BLF_15dd_PIC_v2.1

Cereal_Killer.

2 layer board of 0.60x0.60 inches (15.11x15.11 mm).
Shared on October 9th, 2014 07:24.

Open source direct driver LED driver running a PIC 12F617 with FW by Tterev3. See post #1360 in this thread (http://budgetlightforum.com/node/33927)

U1 is PIC 12F617
D1 is SOT-323
C1 is 10uf 0805 X7R (found to be NOT NEEDED)
C2 is 2.2-10uf (almost anything will work) Stack zener over cap for multi-cell use
D1 = SOD-323 (pad is used for 0805 200ohm resistor if zener modded)
FET is SOT-23-3 (such as AO3400A or IRLML2502)

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project

BLF 17dd_PIC_v2.1

Cereal_Killer.

2 layer board of 0.67x0.67 inches (17.02x17.02 mm).
Shared on October 9th, 2014 07:24.

Open source direct driver LED driver running a PIC 12F617 with FW by Tterev3. See post #1360 in this thread (http://budgetlightforum.com/node/33927)

D1 is SOT-323
C2 is 10uf 0805 X7R (found to be NOT NEEDED)
C1 is 2.2-10uf (almost anything will work) Stack zener over cap for multi-cell use
D1 = SOD-323 (pad is used for 0805 200ohm resistor if zener modded)
FET is D2PAK such as AOD510 or (the no longer available Vishay 70N02)

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project