OSH Park
Profile for RobotHacker
Shared projects
Staff v2
by
RobotHacker.
2
layer board of
1.30x0.75
inches
(33.12x19.10
mm).
Shared on
May 31st, 2017 22:17.
Untested. Ordered 2017-05-31. Updates to follow.
Made with Autodesk Circuits (formerly 123D Circuits.) I am working on the documentation there then copying it here.
https://circuits.io/circuits/5009781-staff
My roommate wants to put a glowing crystal at the top of a staff. I threw together a circuit with a ESP8266, a WS2812 jewel module (7 addressable RGB LEDs,) a 14500 LiPo battery, and a LiPo charging module.
B- and B+ go to a LiPo battery (14500 in my case)
S goes to a switch to turn it on or off (short to turn on.) Battery can still be charged with it turned off.
L-, LD, and L+ go to a string of WS2812 LEDs. L- is GND, L+ is VCC, and LD is the data or signal line. I’m using a “jewel” module with 7 WS2812s on it.
TX, Rx, G0, and RST are for programming the ESP8266
G4, G5, and G16 are GPIOs from the ESP8266 for adding other components later.