Staff v2

by RobotHacker.
Top
Bottom

2 layer board of 1.30x0.75 inches (33.12x19.10 mm).
Shared on May 31st, 2017 22:17.

Untested. Ordered 2017-05-31. Updates to follow.

Made with Autodesk Circuits (formerly 123D Circuits.) I am working on the documentation there then copying it here.

https://circuits.io/circuits/5009781-staff

My roommate wants to put a glowing crystal at the top of a staff. I threw together a circuit with a ESP8266, a WS2812 jewel module (7 addressable RGB LEDs,) a 14500 LiPo battery, and a LiPo charging module.

B- and B+ go to a LiPo battery (14500 in my case)

S goes to a switch to turn it on or off (short to turn on.) Battery can still be charged with it turned off.

L-, LD, and L+ go to a string of WS2812 LEDs. L- is GND, L+ is VCC, and LD is the data or signal line. I’m using a “jewel” module with 7 WS2812s on it.

TX, Rx, G0, and RST are for programming the ESP8266

G4, G5, and G16 are GPIOs from the ESP8266 for adding other components later.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project