OSH Park
Profile for pdablue
Shared projects
PS5VBB.zip
by
pdablue.
2
layer board of
0.66x1.98
inches
(16.81x50.29
mm).
Shared on
February 14th, 2017 16:51.
+5V DC Power Supply for a Breadboard. This board was designed using DipTrace.
rsbb5volt.zip
by
pdablue.
2
layer board of
0.42x2.27
inches
(10.64x57.63
mm).
Shared on
February 2nd, 2017 20:33.
+5v Breadboard Power Supply for a RadioShack breadboard. This pcb was designed using DipTrace.
BBVM.zip
by
pdablue.
2
layer board of
1.21x0.46
inches
(30.66x11.58
mm).
Shared on
February 2nd, 2017 20:11.
This pcb was designed using DipTrace. This pcb was designed to be mounted to the Mini-In-The-Box Mini Voltmeter. The pcb connects to 4 male header pins that allow it to be plugged into a Breadboard power rail. The Voltmeter has two wires: Red wire for the positive voltage side and a Black wire for the negative voltage side. The Red wire is soldered to the + pad. The Black wire is soldered to the - pad. There is a pair of + and - pads on each side of the pcb but you only need to solder the Red and Black wires from the Voltmeter Module to one pair of + and - pads. The large circular hole in the center of the pcb allows you to access to the potentiometer on the back of the mini voltmeter so you can adjust it.
