BBVM.zip

by pdablue.
Top
Bottom

2 layer board of 1.21x0.46 inches (30.66x11.58 mm).
Shared on February 2nd, 2017 20:11.

This pcb was designed using DipTrace. This pcb was designed to be mounted to the Mini-In-The-Box Mini Voltmeter. The pcb connects to 4 male header pins that allow it to be plugged into a Breadboard power rail. The Voltmeter has two wires: Red wire for the positive voltage side and a Black wire for the negative voltage side. The Red wire is soldered to the + pad. The Black wire is soldered to the - pad. There is a pair of + and - pads on each side of the pcb but you only need to solder the Red and Black wires from the Voltmeter Module to one pair of + and - pads. The large circular hole in the center of the pcb allows you to access to the potentiometer on the back of the mini voltmeter so you can adjust it.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project