Rx5808 fpv receiver V1.1

by spikey.
Top
Bottom

2 layer board of 1.59x1.50 inches (40.34x38.13 mm).
Shared on February 10th, 2016 11:42.

Same as previous, just a bit smaller. FPV receiver, based on rx5808 PRO.
unmodded rx5808 from ebay

Modded rx5805 Module is needed to enable SPI. the switch on the bottom of the PCB is to switch between atmega-generated “config” and “FPV” screen. ISP programming header on test pads. Parst List. VIN should be 5-16V.

I still have a couple of blank boards, that I have no use of. Shoot me an email.

here are two renderings Alt text Alt text

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project