OSH Park
Shared projects
15098^1
by
epccs.
2
layer board of
1.70x1.55
inches
(43.18x39.37
mm).
Shared on
February 18th, 2016 06:22.
CC03
Uses an LT3652 buck charge controller, it is optimized to step down a 36 cell solar panel and charge a 12V SLA battery.
Dual Stepper Driver v.3
by
N3M0.
2
layer board of
1.00x1.50
inches
(25.43x38.13
mm).
Shared on
February 17th, 2016 17:50.
Stepper driver for two motors.
LED Ring
by
N3M0.
2
layer board of
1.18x1.38
inches
(30.02x35.00
mm).
Shared on
February 17th, 2016 17:50.
LED Ring for Proxxon Micromot.
rx5808 Nano Board
by
pfriedel.
2
layer board of
3.94x1.54
inches
(100.00x39.01
mm).
Shared on
February 17th, 2016 15:50.
Half the height, all the fun. Ok, only 15mm out of 54, but it’s an important 15mm. Only change to the BOM is an Arduino Nano replacing a Pro Micro. Some quality of life improvements to the layout, but nothing significant.
[untested] H1 hybrid FET+1 17mm v005
by
Pablo_E.
2
layer board of
0.68x0.68
inches
(17.22x17.22
mm).
Shared on
February 17th, 2016 15:14.
SSU Attiny / 0603 res-caps-diode / SOD323 diode / FET gate pulldown resistor
Changes from v004:
-0603 diode pads
-More exposed copper on top GND ring
-Added copper pour under MCU for temp sensoring
-Wider bottom GND ring near FET vias