OSH Park
Shared projects
Triple Cree XP solder paste stencil
by
Helios-.
2
layer board of
0.79x0.79
inches
(20.02x20.02
mm).
Shared on
November 19th, 2014 16:23.
DO NOT ORDER HERE.
Instead download zip file then upload to OshStencils.com. This stencil should work for triple noctigon 20mm stars. Untested.
At OshStencils.com, scroll to the bottom 3 files. Select Engrave Top Stencil (other 2 files are automatically selected).
Change stencil border to 0.75
It will look like this when done.
Price is $2.49. OshStencils has a minimum charge of $5 so add a second one to your cart or add my Cree XM & XP stencil (unless want to pay $5 for one stencil). Shipping: USPS First class (no tracking) $0.70, w/ tracking $1.95, International $3.25.
For personal, non commercial use.
RMM / Richard McDougal of mtnelectronics.com may sell this on his site if he wishes. I sent him a copy some time ago.
.
W & L Tactile Metronome
by
Rasyoung.
2
layer board of
2.12x1.52
inches
(53.87x38.66
mm).
Shared on
November 19th, 2014 14:25.
PIC 16F, 3 X 7 Segment
W2SG0008iGPSTeensy3.1AddOn.v01x
by
PeskyProducts.
2
layer board of
0.71x0.76
inches
(17.91x19.30
mm).
Shared on
November 19th, 2014 06:19.
Wi2Wi W2SG0008i 1.575MHz GPS module add-on shield for Teensy 3.1. A mechanical switch toggles between UART and I2C output; 4K7 pullup resistors are on the SDA/SCL lines. Solder jumpers can be used to choose 4800 (default), 9600, and 38400 BAUD rates for NMEA protocol output to UART on Teensy Serial2, I2C supports both 100 kHz and 400 kHz rates. Solder jumpers can be used to take power and ground from the board edge transforming the shield into a conventional breakout board for breadboard use. The shield was designed for the 3V3 VIN of the Teensy but the LDK130 1.8V voltage regulator required by the GPS module can take up to 5.5V as input, making the shield in breakout-board mode ideal for any Arduino platform, even the Arduino UNO. The serial and I2C signals are logic level translated up to VIN on output from the board and down to the 1.8 V of the GPS module’s digital IO on input. There is a small SPDT button switch that sends the required ON/OFF signal to the GPS module. The passive chip antenna placement is less than perfect since it lacks a sufficiently ground-shielded feed line, which is not really wide enough to make the 50 Ohm needed. This is a compromise for the small size of the board, which allows the add-on function without overwhelming the Teensy form factor.
TC-IF Rev 1
by
UnifiedEngineering.
2
layer board of
0.68x0.91
inches
(17.20x23.16
mm).
Shared on
November 19th, 2014 01:49.
Thermocouple 1-wire interface
Mattthemuppet's bikelight V0.4
by
Cereal_Killer.
2
layer board of
1.03x1.03
inches
(26.11x26.11
mm).
Shared on
November 18th, 2014 23:48.
http://budgetlightforum.com/node/35674