OSH Park
Shared projects
- You need to sign in or sign up before continuing.
Zstar-GE V1
by
Joshevelle.
2
layer board of
1.50x2.01
inches
(38.02x51.00
mm).
Shared on
October 15th, 2014 17:58.
Ultra low cost Zigbee EVB
DE0-Nano Breakout (VGA, 7-Seg & Push Buttons)
by
Muxelmann.
2
layer board of
2.96x1.93
inches
(75.18x49.02
mm).
Shared on
October 15th, 2014 16:07.
This is a breakout board with VGA for the Terasic DE0-Nano
LSM9DS1+MS5611TeensyMiniAddOn.v01x
by
PeskyProducts.
2
layer board of
0.71x0.51
inches
(17.93x12.98
mm).
Shared on
October 15th, 2014 06:06.
ST Microelectronics' newest 9-axis motion sensor the LSM9DS1 plus Measurement Specialties' MS5611 pressure sensor with hardwired I2C. The board is designed to be either a mini Teensy 3.1 add-on board with SDA/SCL on pins 17/16 and power taken at the Teensy end, or the solder jumpers on the back can allow power to be taken from the edge of the board for convenient breadboarding like a traditional breakout board. The board is designed in mini-add-on mode to keep the hardware SPI pins free for other add-ons like an SD card or rf radio that must use SPI. One interrupt each from the accel, gyro, and mag is broken out and solder jumpers can allow access to the other two interrupts, if desired. Solder jumper can also be used to change the address of the LSM9DS1. Removed ground plane in LSM9DS1 sensor footprint to reduce interference with magnetometer.
blink4
by
electrodog10.
2
layer board of
0.84x1.20
inches
(21.26x30.48
mm).
Shared on
October 15th, 2014 01:34.
final…
funky drawb
by
mattvenn.
2
layer board of
3.05x1.04
inches
(77.42x26.42
mm).
Shared on
October 14th, 2014 14:52.
funky drawb