OSH Park
Shared projects
Sensor Board v2.brd
by
eraticus.
2
layer board of
1.35x0.75
inches
(34.29x19.05
mm).
Shared on
May 31st, 2017 22:51.
Corrected power traces to op amps
APA102 Breakout Rev 2
by
arbartz.
2
layer board of
2.53x2.53
inches
(64.26x64.26
mm).
Shared on
May 31st, 2017 22:28.
Staff v2
by
RobotHacker.
2
layer board of
1.30x0.75
inches
(33.12x19.10
mm).
Shared on
May 31st, 2017 22:17.
Untested. Ordered 2017-05-31. Updates to follow.
Made with Autodesk Circuits (formerly 123D Circuits.) I am working on the documentation there then copying it here.
https://circuits.io/circuits/5009781-staff
My roommate wants to put a glowing crystal at the top of a staff. I threw together a circuit with a ESP8266, a WS2812 jewel module (7 addressable RGB LEDs,) a 14500 LiPo battery, and a LiPo charging module.
B- and B+ go to a LiPo battery (14500 in my case)
S goes to a switch to turn it on or off (short to turn on.) Battery can still be charged with it turned off.
L-, LD, and L+ go to a string of WS2812 LEDs. L- is GND, L+ is VCC, and LD is the data or signal line. I’m using a “jewel” module with 7 WS2812s on it.
TX, Rx, G0, and RST are for programming the ESP8266
G4, G5, and G16 are GPIOs from the ESP8266 for adding other components later.
RPI HAT 5
by
Designer23.
2
layer board of
2.62x2.21
inches
(66.62x56.03
mm).
Shared on
May 31st, 2017 20:41.
Upside ADC with side socket Raspberry Pi 2 HAT for ADS1256 blue module mounted upside down on HAT
EPM7128_test_board
by
basis108.
2
layer board of
2.28x3.05
inches
(57.86x77.47
mm).
Shared on
May 31st, 2017 20:03.
EPM7128_test_board