OSH Park
Shared projects
ESP8285.v01
by
PeskyProducts.
4
layer board of
0.71x0.61
inches
(17.96x15.39
mm).
Shared on
April 17th, 2016 19:03.
ESP8285 with embedded 1 MB flash as an environmental data logger with BME280 pressure, temperature, humidity sensor and VEML6070 UV light sensor powered by small LiPo battery. All GPIOs broken out to add sensors, voltage divider on ADC to monitor battery voltage, edge through-holes line up with FTDI connector for easier programming.
Arduino Mini CAN-Bus
by
DF2RO.
2
layer board of
0.70x1.30
inches
(17.78x33.02
mm).
Shared on
April 17th, 2016 14:26.
This board can be soldered with pinheaders onto an Arduino Mini. It contains the MCP2515 CAN bus controller and the MCP2551 CAN tranceiver. The MCP2515 is connected to the hardware-SPI of the ATMega328p.
There are some jumpers:
| Jumper | Function |
|---|---|
| TERM | Connects an 120 Ohm bus termination to the CAN-lines. |
| SCK | Connects the ATMega328p’s clock output (Arduino pin 8/PB0/CLK0) to the MCP2515’s clock input. |
| CS | Connects the MCP2515’s chip select line to Arduino pin 10(PB2/SS). |
| INT | Connects the MCP2515’s interrupt line to either Arduino pin 2 (PD2/INT0) or Arduino pin 3 (PD3/INT1). |
If you want to use other pins you can solder a wire to the jumper pad
This project on my GitHub-page: https://github.com/robinolejnik/arduino_mini_can_bus
Hexagon HQ10D
by
HQ.
2
layer board of
0.69x0.69
inches
(17.63x17.63
mm).
Shared on
April 17th, 2016 10:34.
17.6mm, double-sided, 10x7135, double-channel, OTC
Nanjg replacement for a linear driver up to 3.8 Ampere
v1.23
this board is provided as is and without any warranty, even without the implied warranty of fitness for a particular purpose
ECET Summer Amp 2016
by
eraticus.
2
layer board of
3.00x3.00
inches
(76.20x76.20
mm).
Shared on
April 17th, 2016 09:15.
v1
Dual K-Type Thermocouple Display
by
sjm.
2
layer board of
1.71x1.43
inches
(43.31x36.22
mm).
Shared on
April 17th, 2016 04:44.
A PIC micro-controller reads two independent temperature channels, and writes to a 16x1 LCD.
Also includes data logging, writing values to a remote RS-232 terminal.
The PCB mounts directly to the rear of the LCD.
