esp8266 wroom-02 Breakout

2 layer board of 1.02x1.15 inches (25.91x29.16 mm).
Shared on April 17th, 2016 03:04.

Breakout board for the wroom-02. All pins are tied directly to their corresponding pad.

Short en to have the enable pin tied to power.

Add 10k resistors R1, R2, R3 to make the module go into flash boot mode on startup.

Add the KMR221GLFS switch so you can easily put the module into flash mode.

Copy this HTML into your page to embed a link to order this shared project

TRIAC Driver (TO-3)

2 layer board of 1.71x0.91 inches (43.31x23.01 mm).
Shared on April 16th, 2016 22:02.

TRIAC driver for the Solid State Power Strip project.

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 1.68x1.01 inches (42.55x25.55 mm).
Shared on April 16th, 2016 22:02.

TRIAC driver for the Solid State Power Strip project. For use with a TO-263 (D2 Pack) device.

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 2.17x1.13 inches (54.99x28.60 mm).
Shared on April 16th, 2016 22:02.

Controller for the Solid State Power Strip project.

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 1.40x1.60 inches (35.59x40.64 mm).
Shared on April 16th, 2016 22:02.

Sensor breakout biased on Arduino Pro Mini

Copy this HTML into your page to embed a link to order this shared project