ERLT Transponder FC 36mm Mount

by ryanb.
Top
Bottom

2 layer board of 0.60x1.43 inches (15.11x36.42 mm).
Shared on May 22nd, 2016 18:50.

ERLT Transponder FC 36mm Mount

ERLT LiPO Powered transponder w/ 5V regulator

This project has been race tested and is easy to solder. The transponder support 2s or 3s lipo input (7.4V or 11.1V nominal) or a 5V input. The onboard voltage regulator steps the voltage down to 5V.

Parts List: * Attiny85 ATTINY85-20SU

  • 940 nm IR diode TSAL 6100 or equivalent

  • 1206 ΒΌ W resistors (R1 33ohm, R2 330ohm, R3 100ohm, R4 150ohm)

  • 1206 LED (LED2 - activity, LED3 - power status)

  • Q1 2N2222 surface mount (SOT23 format)

  • VREG 5V LDO 250mA (MCP1702T-5002E/CB)

  • 1206 1uF capacitor (C1, C2)

  • SMD Tactile button

Note: only equip 1 IR LED at a time. You can have both installed, however the power output will be halfed.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project