New release: 1.3.1

« OctoPrint On Air #8 New release candidate: 1.3.1rc2 »

As the first release of 2017, 1.3.1 brings you a long list of fixes and improvements again.

Judging by some of the feedback I got over the past couple of weeks since releasing 1.3.0 one of the most anticipated changes in this release might be support for disabling the cancel confirmation by unchecking “Settings > Features > Confirm before cancelling a print”. If I’d known how strongly a lot of you apparently think about this, I’d shipped 1.3.0 directly with this, so make sure to give me feedback during development instead of after :)

Making the cancel confirmation optional naturally is not the only thing that went into this release though, here’s a small excerpt from the Changelog:

Way better support for various password managers.
Support for calculating filament volume for GCODE files sliced with Simplify3D.
Improved set of stock terminal filters. Please note that if you modified your terminal filters you’ll need to update the included stock filters manually if needed.
Fixed some left over issues with folder management.
Fixed backwards compatibility of the new command line interface.
Fixed a bug in the model size calculation that caused wrong sizes to be calculated under specific circumstances.
Fixed a bug in the shipped init script. If you installed OctoPrint manually (e.g. not via OctoPi) and used the included init script, you’ll need to update that manually or your server might not start!

There are two heads-ups for upgraders from earlier versions, to quote the Changelog:

If you installed OctoPrint manually and used the included init script, you need to update that

The init script so far shipped with OctoPrint contained a bug that causes issues with OctoPrint 1.3.0 and higher. Please update your init script to the fixed version OctoPrint now ships under scripts:
sudo cp /path/to/OctoPrint/scripts/octoprint.init /etc/init.d/octoprint
If you are running OctoPi, this does not apply to you and you do not need to do anything here!

Change in stock terminal filter configuration

1.3.1 fixes an issue with the two terminal filters for suppressing temperature and SD status messages and adds a new filter for filtering out firmware wait messages. These changes will only be active automatically though for stock terminal filter configurations. If you have customized your terminal filters, you’ll need to apply these changes manually under “Settings > Terminal filters”:

Changed “Suppress temperature messages” filter, new regex is (Send: (N\d+\s+)?M105)|(Recv: ok (B|T\d*):)

Changed “Suppress SD status messages” filter, new regex is (Send: (N\d+\s+)?M27)|(Recv: SD printing byte)

New “Suppress wait responses” filter, regex is Recv: wait

The full list of changes can of course be found in the Changelog - as always.

Also see the Further Information and Links below for more information, where to find help and how to roll back. Thanks!

edit 2017-01-26 Added additional heads-ups for upgraders from release notes

Further Information

It may take up to 24h for your update notification to pop up, so don’t be alarmed if it doesn’t show up immediately after reading this. You can force the update however via Settings > Software Update > Advanced options > Force check for update.

If you don’t get an “Update Now” button with your update notification, read this or - even more specifically - this.

If you are running 1.2.7, get an “Update Now” button but the update is immediately reported to be successful without any changes, read this.

If you are running 1.2.16, get an “Update Now” button but the update is immediately producing an error message, read this.

If you have any problems with your OctoPrint installation, please seek support in the G+ Community or the Mailinglist.